Kompernass KH 1171 Operating Instructions Manual page 11

The function "Rapid" is only available with
Programmes 1-4.
A bread weight level cannot be selected with the
Programmes 6, 7, 11 and 12.
10. You now have the option of setting the end time
of your programme using the timer function.
You can enter in a maximum time delay of up
to 15 hours.
Note
This function is not available for Programmme 11.
Starting the Programme
Now start the programme with the Start/Stop button
.
Note: The Programmes 1, 2, 3, 4, 6, 8 and
9 start with a 10 to 30 minute pre-heat phase
(except Rapid, see Table for Programme
Sequences). The kneading paddles
move themselves. That is not an error of the
machine.
The Programme automatically carries out the
various operations.
You can watch the programme sequence via the
window of your Bread Baking Machine.
Occasionally, condensation may collect in the win-
dow during baking . The appliance lid
opened during the kneading phase.
Note
Do not open the appliance lid
or baking phases. The bread could collapse.
Ending the Programme
When the baking process has been completed, ten
acoustic signals are sounded and the display
indicates 0:00.
At the end of the programme the appliance automa-
tically changes to a keep-warm mode for up to 60
minutes.
This is not applicable to Programmes 6, 7 and 11.
In this mode, warm air circulates inside the appliance.
The keep warm period can be prematurely termina-
ted by pressing down the Start/Stop button
the signal tone sounds.
Before opening the appliance lid
plug from the wall socket.
When not in use, the appliance should never be
plugged in!
Taking out the bread
When handling the hot baking mould,
do not use pot holders or oven gloves.
Hold the baking mould
shake it lightly until the bread slides out of the
baking mould
If the bread does not slip off the kneading paddles
the supplied kneading paddle remover
can be
Do not use any metal objects which may cause
scratches on the non-stick coating.
After removing the bread, immediately rinse the
during the rising baking mould
kneading paddles
shaft.
Tip: If you remove the kneading paddles
- 11 -
Note
Warning
.
, carefully remove the kneading paddles
Note
with warm water. This prevents the
from sticking to the driving
the last kneading of the dough, the bread will
remain intact when you remove it from the
baking mould .
until
remove the power
always
tilted over a grid and
using
.
after