Step 3: Connecting Speakers; Step 4: Connecting A Usb Device Or A Memory Card; Step 5: Connecting - Philips MCD988/98 User Manual

Connections
●
Place the front left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
Notes:
– To avoid magnetic interference, do not position
the front speakers too close to your TV set.
– Allow adequate ventilation around the DVD
System.

Step 3: Connecting speakers

●
Install the speakers to the corresponding stand
with screws.
●
Connect the left and right speakers to the
SPEAKERS (4Ω) terminals on the back of the
subwoofer with the supplied speaker cables.
Right speaker to "R" and left speaker to "L". Fully
inser t the speaker wire into the terminal.
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
– To install the speakers on the wall, please see
the Appendix for wall mounting instructions.
10
Step 4: Connecting a USB device
or a memory card
●
By connecting a USB mass storage device
(including USB flash memory, USB flash players
or memory cards) to the Hi-Fi system, you can
enjoy the device's stored music through the
powerful speakers of Hi-Fi system.
Slide down the protective cover
before plugging in the USB
device.
Insert the USB device's USB plug into the
socket on the set.
OR
for the devices with USB cables:
1
Insert one plug of the USB cable (not supplied)
to the socket on the set.
2
Insert the other plug of the USB cable to the
USB output terminal of the USB device.
OR
for the memory card:
1
Insert the memory card into a card reader (not
supplied).
2
Use a USB cable (not supplied) to connect the
card reader into the
Step 5: Connecting TV
IMPORTANT!
– You only need to make one video
connection from the following options,
depending on the capabilities of your TV.
– Connect the DVD system directly to
the TV.
socket on the set.