Connections; Step 1: Placing Speakers And Subwoofer; Step 2:Connecting Speakers And Subwoofer - Philips FWD876/98 User Manual

Connections

Step 1: Placing speakers and
subwoofer
For best possible surround sound, all speakers
(except subwoofer) should be placed at the
same distance from the listening position .
● Retrieve the speaker grilles from the packing
box and fix onto the active speakers as show
below :
fix onto the
active speaker
retrieve the
speaker grill from
the packing box
● Place the front left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening.
● place the center speaker above the TV set, so
the center channel's sound is localized.
● Place the surround speaker at normal listening
ear level facing each other or mounted on the
set .
● Place the subwoofer on the floor near the TV
set.
Notes:
– To avoid magnetic interference, do not position
the front speakers too close to your TV set.
– Allow adequate ventilation around the DVD
MINI HI-FI System.
IMPORTANT!
The type plate is located on the rear of
the system.
10
finished-speaker
To avoid overheating of the system, a
safety circuit has been built in.
Therefore, your system may switch to
Standby mode automatically under
extreme conditions. If this happens, let
the system cool down before reusing it.
Step 2:Connecting Speakers and
Subwoofer
left speaker
110 127V 220 240V
SPEAKERS
SR
6
Speaker
(right)
● Connect the speaker wires to the SPEAKERS
(FRONT) terminals, right speaker to "R" and left
speaker to "L", coloured (marked) wire to "+" and
black (unmarked) wire to "–". Fully insert the
stripped portion of the speaker wire into the
terminal as shown.
● Connect the Surround Speakers and Center
Speaker system using the supplied speaker cable
to the speaker jacks on the SUBWOOFER by
matching the colours of the jacks and speaker
plugs.
● Connect the subwoofer using the supplied
speaker cable to the DIN OUT jack on the DVD
MINI HI-FI System.
● Connect the AC MAINS .
Notes:
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
center speaker
Right speaker
e r
AC MAINS
C SL
DIN
3 6
INPUT
Speaker
(left)