Removing Clutch Shoes And Springs; Installing Clutch Shoes - Yamabiko Echo SRM-2620ES Service Manual

SRM-2620ES, SRM-2620TES
T262XS, C262S
T262TXS, C262TS

5-1 Removing clutch shoes and springs

A
B
C

5-2 Installing clutch shoes

A
B
C
Fan cover side
CLUTCH SYSTEM
Mountain side
Clutch side
Valley side
1. Remove muffler cover, engine cover and fan
cover.
2. Install rope (A) into spark plug hole by hand, to
stop crankshaft rotation.
NOTE: Do not use power tool. Otherwise, piston
damage may occur.
3. Rotate bolts (B) counterclockwise using 13 mm
(0.51 in.) box wrench (C) or similar tool to remove
clutch assembly.
4. Check clutch shoes for wear and spring for
weakness or damage. Replace clutch parts as re-
quired.
NOTE: Replace two shoes together with new ones
to maintain balance even if one shoe is defective.
1. Pre-assemble clutch hub, clutch shoes and
springs.
2. Install rope (A) into spark plug hole by hand, to
stop crankshaft rotation.
NOTE: Do not use power tool. Otherwise, piston
damage may occur.
3. Tighten bolts (B) clockwise using 13 mm (0.51
in.) box wrench or similar tool.
4. Remove rope (A), and reinstall other parts in
place.
NOTE: Install spring washers (C) paying attention
direction as shown.
39