Replacing Ignition Switch - Yamabiko Echo SRM-2620ES Service Manual

SRM-2620ES, SRM-2620TES
20
T262XS, C262S
IGNITION SYSTEM
T262TXS, C262TS

3-5 Replacing ignition switch

A
For SRM-2620ES, SRM-2620TES, T262XS and
T262TXS (L handle)
1. Remove screws (A) and remove rear handle
grip half (B) from drive shaft housing.
B
2. Remove screws (C) from brackets (O) and re-
D
move another rear handle grip half (D) from drive
O
shaft housing.
C
3. Disconnect primary lead coupler (P) and ground
lead coupler (Q). Disconnect throttle cable from
carburetor.
Q
P
4. Disconnect end (e) of throttle cable (E) from
L
throttle trigger (G).
K
E
J
e
5. Remove throttle trigger (G) with torsion spring (H)
and throttle lockout lever (J) with torsion spring (K).
6. Remove ignition switch (L) with leads, corrugat-
ed tube (M) and throttle cable (E).
7. Pull out throttle cable from corrugated tube.
M
8. Pass throttle cable (E) through corrugated tube
G
H
(M) of new ignition switch.