Replacing Spark Plug Cap And Coil; Replacing Ignition Coil - Yamabiko Echo SRM-2620ES Service Manual

24

3-7 Replacing spark plug cap and coil

A

3-8 Replacing ignition coil

D
B
C
IGNITION SYSTEM
B
A
C
A
1. Disconnect spark plug cap (A) from spark plug.
2. Apply some oil in spark plug cap (A) for easy re-
moval from high tension lead (B).
3. Pull spark plug cap away from high tension lead.
4. Inspect spark plug cap coil (C) for correct con-
nection and corrosion. Inspect spark plug cap for
cracks. Replace as required.
NOTE: Make sure spark plug cap coil (C) contacts
center core of high tension lead when reinstalling
it.
5. Coat with small amount of oil to the end of high
tension lead (B) and insert it to spark plug cap (A)
as shown until the spark plug cap coil is properly
seated in the cap.
Coat with small amount of oil
B
1. Disconnect spark plug cap (A) from spark plug.
2. Remove muffler cover, cylinder cover and fan
cover.
3. Disconnect ignition lead set (B) from ignition
coil. Loosen bolts (C) and connector (D) of ignition
coil.
4. Remove ignition coil from cylinder.
5. Remove spark plug cap (A) and spark plug cap
coil from high tension lead (Refer to "3-7 Replacing
spark plug cap and coil").
6. Install spark plug cap (A) and spark plug cap
coil, ignition lead set (B) to new ignition coil.
7. Install new ignition coil by bolts (C) loosely. Set
air gap (Refer to "3-9 Setting pole shoe air gaps").
Install fan cover, cylinder cover and muffl er cover.
8. Connect spark plug cap (A) to spark plug.
SRM-2620ES, SRM-2620TES
T262XS, C262S
T262TXS, C262TS