Cisco ONS 15454 Installation Instructions Manual page 13

Chapter 2 Install Cards and Fiber-Optic Cable
Stop. You have completed this procedure.
NTP-A274 Install the FC_MR-4 Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Class I (CDRH) and Class 1M (IEC) laser products. Statement 1055
Warning
Invisible laser radiation could be emitted from the end of the unterminated fiber cable or connector.
Warning
Do not stare into the beam directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of
100 mm could pose an eye hazard. Statement 1056
Use of controls, adjustments, or performing procedures other than those specified may result in
Warning
hazardous radiation exposure. Statement 1057
Warning High-performance devices on this card can get hot during operation. To remove the card, hold it by
the faceplate and bottom edge. Allow the card to cool before touching any other part of it or before
placing it in an antistatic bag. Statement 201
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
Caution
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
78-17697-01
This procedure installs the FC_MR-4 card, also known as the Fibre
Channel card.
FC_MR-4 card(s)
NTP-A15 Install the Common Control Cards, page 2-2
As needed
Onsite
None
NTP- A274 Install the FC_MR-4 Card
Cisco ONS 15454 Procedure Guide, R8.0
2-13