Cisco ONS 15454 Installation Instructions Manual page 10

NTP- A17 Install the Electrical Cards
Stop. You have completed this procedure.
NTP-A17 Install the Electrical Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
Caution
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Do not install low-density DS-1 cards in the same side of the shelf as DS3/EC1-48 cards.
Caution
Caution Do not install a DS3/EC1-48 card in Slots 1 or 2 if you have installed an MXP_2.5G_10G card in Slot 3.
Likewise, do not install a DS3/EC1-48 in Slots 16 or 17 if you have installed an MXP_2.5G_10G card
in Slot 15. If you do, the cards will interact and cause DS-3 bit errors.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
Install higher-capacity cards first; for example, install a DS-3 card before installing a DS-1 card. Let
Note
each card boot completely before installing the next card.
If you are installing OC-N, transponder (TXP), or muxponder (MXP) cards, Cisco recommends that you
Note
install these before you install electrical cards, as applicable.
If you installed XC or XCVT cards, review
Step 1
If you installed XC10G or XC-VXC-10G cards, review
compatibility.
Cisco ONS 15454 Procedure Guide, R8.0
2-10
This procedure describes how to install electrical cards (DS-1, DS-3,
DS3XM, and EC-1).
Electrical cards
NTP-A15 Install the Common Control Cards, page 2-2
As needed
Onsite
None
Table 2-1 on page 2-3
Chapter 2 Install Cards and Fiber-Optic Cable
to determine card/slot compatibility.
Table 2-2 on page 2-5 to determine card/slot
78-17697-01