Tuning to radio stations
1
Press SOURCE on the front panel repeatedly
(or TUNER on the remote control) to select
FM mode.
2
Hold TUNING S / T and then release
the button.
➜
The display will show "SEARCH" until a radio
station with sufficient signal strength is found.
➜
If a FM station is received in stereo,
shown.
3
Repeat step 2 if necessary until you find the
desired station.
●
To tune to a weak station, press TUNING
S / T briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press ALBUM/PRESET 4 / 3 to select the
preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROG on the remote control for more
than two seconds to activate programming.
➜
All available stations are programmed.
Manual programming
1
Tune to your desired station (refer to "Tuning to
radio stations").
2
Press PROG to activate programming.
➜
PROG flashes in the display.
3
Press ALBUM/PRESET 4 / 3 to allocate a
is
number from 1 to 40 to this station.
4
Press PROG again to confirm the setting.
➜
PROG disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.
Radio Reception
17