Table of Contents
Advertisement
Installation: Wall Mounted Salamander and Shelf Assembly for
36", 48" and 60" Wide Units
1. Each gas appliance shall be located with respect to building construction and other equipment so as to permit
access to the appliance. Such access and clearance is necessary for service and cleaning.
2. A weld wall mount Salamander and shelf assembly, which includes two (2) hi-hat supports, one (1) lower
support angle, one (1) upper support angle, one (1) rear shelf panel, one (1) shelf and one (1) Salamander
bottom panel. Also hardware required for attachment of components.
3. Review pages 4 & 5 as a reference for mounting the wall mount kit. Drilled holes are required in both the
upper and lower left to right supports. (Added by others), before any mounting can take place.
NOTE: Installer is responsible for mounting hardware as well as insuring that the wall mount assembly
once positioned in place can support a minimum of 200lbs.
4. After the wall mount unit has been installed, remove the second screw back from the front top piece (1) from
the left side (1) from the right side. Slide the Salamander in between the flanges of the wall mount assembly.
By keeping the front flush with the wall mount brackets, the bottom mounting holes should line up. With the
(4) 1/3 – 20 x 1" bolts supplied from the factory, secure the Salamander to the bottom flanges of the wall
mount assembly.
5. Attach the upper shelf angle to the top rear support with (2) sheet metal screws provided. Attach the lower
shelf angle to the bottom rear support with (2) sheet metal screws .
6. Next position and attach the shelf back panel to the (2) angles added in step 6.
7. Attach the shelf with (3) 10-24 machine screws provided. Make adjustments as necessary.
8. Attach the bottom panel and use the (4) plug buttons to seal the ½" holes.
9. Replace the screws removed in step 5. Assembly is complete.
All specifications are subject to change without prior notification
Advertisement
Table of Contents
