IA/IAX CALPAC INSTALL Step 1: Step 2: One of the (7) screws holding the old CALpac has a protective adhesive covering the top of the screw. Carefully Using a high-quality T9 Torx driver, remove the (7) screws that are attaching the box to the frame. Note that older remove it using a sharp tool to expose the screw head.
Page 3
IA/IAX CALPAC INSTALL (CONTINUED) Refer to the appropriate cable routing diagram to insure correct cable routing Pages: 4-10 Step 5: Attach the CALpac to the frame with (2) M3 Flathead screws. Use the screws that you saved from step 2 or use the new screws provided with your CalPac.
IA/IAX CALPAC INSTALL (CONTINUED) Step 8: Step 9: Attach the front of the top of the CALpac together using the remaining 12mm M3 screw. As before, note that the While flexing the rubber part of the cover out of the way, carefully screw the box down to the frame using the (4) screws are self-tapping, so great care must be taken on the first installation.