Ia/Iax Calpac Install - Felt CALPAC IA Manual

Step 1:
One of the (7) screws holding the old CALpac has a protective adhesive covering the top of the screw. Carefully
remove it using a sharp tool to expose the screw head.
Step 3:
If you prefer to leave the existing cable routing intact, use side cutters to cut out a slot in in the cable routing tower to
free the cables.

IA/IAX CALPAC INSTALL

Step 2:
Using a high-quality T9 Torx driver, remove the (7) screws that are attaching the box to the frame. Note that older
IA and IAx models utilized Hex screws. Use a high-quality 2mm hex driver to remove those screws. DO NOT use a ball-end style
driver. Do NOT throw away these screws as they are used in the latter installation step as well as in other applications
on your bicycle.
Step 4:
Insert the new box in the direction shown above taking care to make sure that all of the cables entering the frame
are routed in front of the CALpac and are not trapped on the side between the frame and the box.
2