Felt CALPAC IA Manual page 3

Refer to the appropriate cable
routing diagram to insure
correct cable routing
Pages: 4-10
Step 6:
Starting with the back screw, attach the two halves of the top of your new CALpac together using the shorter (12mm)
of the two sized screws that are provided. Note that the screws are self-tapping, so be especially careful when screwing them in
for the first time. Tighten to 2Nm. DO NOT install the front screw at this point.
IA/IAX CALPAC INSTALL
(CONTINUED)
Step 5:
Attach the CALpac to the frame with (2) M3 Flathead screws. Use the screws that you saved from step 2 or use the
new screws provided with your CalPac. Install the two screws through the two front holes found on each side of the box. Use a T9
Torx driver or a Hex driver, if you have Hex screws, and tighten to 2Nm. DO NOT install the other screws yet.
Step 7:
While flexing the front of the CALpac apart, install it over the cables. Make sure that you correctly route the cables.
Please refer to the diagrams below.
3