Table of Contents
Advertisement
Basic Functions
STANDBY-ON
M I C RO S Y S T E M M C M 1 5 9
iR
CD/CD - R/CD - RW COMPATIBLE
SOURCE
ALBUM/PRESET
DBB
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY" is displayed.
2
Press ÉÅ on the system to start installation.
➜
"PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "TUNER" and "AUTO".
➜
starts flashing.
PROG
➜
The system will automatically store the radio
stations with sufficient signal strength, starting
from FM, and followed by MW band.
➜
When all the available radio stations are
stored or the memory for 40 presets are used,
the first preset radio station will be played.
To reinstall Plug and Play
1
In standby mode, press and holdÉÅ on the
system until "AUTO INSTALL - PRESS PLAY"
is displayed.
2
Press ÉÅ again to start installation.
➜
All previously stored radio stations will be
replaced.
10
VOL
TUNING
MODE
PROG
VOL
(for tuner installlation)
To exit without storing the Plug and Play
●
Press 9 on the system.
➜
If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" will be displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.
Switching the system on
●
Press STANDBY-ON 2 or SOURCE
(POWER, DISC, TUN, or AUX on the
remote control).
➜
The system will switch to the last selected
source.
●
Press DISC, TUN, or AUX on the remote
control.
➜
The system will switch to the selected source.
To switch the system to standby mode
●
Press STANDBY-ON 2 on the system (or
POWER on the remote control).
Power-saving automatic standby
The power-saving feature automatically switches
to standby 90 minutes after a CD playback has
ended and no control is operated.
Adjusting volume and sound
1
Press VOL +/- to adjust volume.
➜
Display shows the volume level VOL and a
number from 0-32.
2
Press DSC repeatedly to select the desired
sound effect: JAZZ / POP / CLASSIC / ROCK.
3
Press DBB to switch bass enhancement on or
off.
➜
Display shows:
4
Press MUTE on the remote control to
interrupt sound reproduction instantly.
➜
Playback will continue without sound.
●
To activate sound reproduction you can:
– press MUTE again;
– adjust the volume controls;
– change source.
if the DBB is activated.
ALB/
PRESET
Advertisement
Table of Contents
