Table of Contents
Advertisement
Other Functions
Radio Reception
Tuning to radio stations
1
Press STANDBY-ON y to switch on the last
selected source.
2
Turn the SOURCE knob on the system (or
press TUNER on the remote control) to select
TUNER (FM) mode.
3
Press and hold 22/33 (or 2/3 on the
remote control) until the frequency indication
starts to change, then release.
➜
The system automatically tunes to the next
strong radio station.
●
To tune to a weak station, press 22/33 (or
2/3 on the remote control) briefly and
repeatedly until an optimal reception is found.
4
Repeat Step 3 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 20 stations regardless of
the reception.
Automatic programming
●
Press PROGRAM on the remote control for
more than two seconds to activate
programming.
➜
All available stations are programmed.
Manual programming
1
Tune to your desired radio station (refer to
"Tuning to radio stations").
2
Press PROGRAM on the remote control.
➜
"AUTO" icon flashes.
3
Press ¡ / ™ to select the desired preset number.
➜
If "AUTO" icon goes off before you select the
desired preset number, press PROGRAM on
the remote control.
4
Press PROGRAM on the remote control again
to store the radio station.
●
Repeat steps 1-4 to store other radio stations.
Listening to preset radio stations
●
In tuner mode, press ¡ / ™ to select the desired
preset number.
➜
The preset number, radio frequency, and
waveband are displayed.
24
Setting sleep/wake-up timer
Sleep timer setting
In power-on mode, the sleep setting enables
the system to switch to standby mode
automatically at a preset time.
1
In power-on mode, press SLEEP/TIMER on
the remote repeatedly to select a preset time.
2
When you reach the desired length of time, stop
pressing SLEEP/TIMER.
➜
"SLEEP" appears.
To deactivate the sleep timer
●
Press SLEEP/TIMER repeatedly until "00" is
displayed, or press STANDBY-ON y.
In standby mode, the timer setting enables the
system to switch on automatically at a set time.
Wake-up timer setting
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
1
Press and hold SLEEP/TIMER until the time
flashes on the display.
➜
"TIME SET" scrolls. Then, the hour digits
flash on the display screen.
2
Turn VOLUME clockwise or anticlockwise or
press VOL +/- on the remote control to set the
hours.
3
Press SLEEP/TIMER to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOLUME clockwise or anticlockwise or
press VOL +/- on the remote control to set the
minutes.
5
Press SLEEP/TIMER to confirm the time
setting.
➜
"OFF" flashes on the display screen.
6
Turn VOLUME clockwise or anticlockwise or
press VOL +/- on the remote control to select
"ON".
➜
icon appears on the display screen.
To deactivate the timer
●
Select "OFF" at Step 6.
Advertisement
Table of Contents
