Connections; Step 1: Placing Speakers; Step 2: Connecting Speakers; Step 3: Connecting The Control Cable - Philips MCD772/73 User Manual

Dvd micro theatre
Hide thumbs Also See for MCD772/73:
Table of Contents

Advertisement

Connections

IMPORTANT!
– The type plate is located at the
bottom of the system.
– Before connecting the AC power cord
to the wall outlet, ensure that all
other connections have been made.
– Never make or change any
connections with the power switched on.
Note:
– The DEMO jack is only applicable to the demo
unit that is not included in the audio system. Do
not attempt to connect any other device to the
audio system through this jack.

Step 1: Placing speakers

Front
speaker
( left )
Place the front left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening position.
Notes:
– To avoid magnetic interference, do not position the
front speakers too close to your TV set.
– Allow adequate ventilation around the DVD System.

Step 2: Connecting speakers

Connect the speaker wires to the SPEAKERS
terminals, right speaker to "R" and left speaker to "L",
coloured (marked) wire to "+" and black (unmarked)
wire to "–". Fully insert the stripped portion of the
speaker wire into the terminal as shown.
1
Speaker wire connection on main set
8
Front
speaker
( right )
VIEWING AREA
2
1
Speaker wire connection on speakers
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Step 3: Connecting the control
cable
Connect the serial port marked CABLE at the
rear of the DVD player to the same por t at the
rear of the power amplifier with the supplied flat
control cable.

Step 4: Connecting TV

IMPORTANT!
– You only need to make one video
connection from the following options,
depending on the capabilities of your TV.
– Connect the DVD system directly to
the TV.

Using Composite Video jack

2
1
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mcd772

Table of Contents