Table of Contents
Advertisement
Radio Reception
Tuning to radio stations
1
Press STANDBY-ONy (or y on the remote)
to switch on the last selected source.
2
Press SOURCE (TUNER on the remote) to
select TUNER mode.
3
Press TUNER on the remote again to select
the desired band: FM or MW (AM).
4
Press and hold ¡ / ™ (TU +/- à / á on the
remote) until the frequency indication starts to
change, then release.
➜
The system automatically tunes to the next
strong radio station.
●
To tune to a weak station, press ¡ / ™ (TU +/-
à / á on the remote) briefly and repeatedly
until an optimal reception is found.
5
Repeat Step 4 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 40 stations (20 in each
band) regardless of the reception.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
●
Press PROG on the remote for more than two
seconds to activate programming.
➜
All available stations are programmed.
Manual progamming
1
Tune to your desired radio station (refer to
"Tuning to radio stations").
2
Press PROG on the remote.
➜
"PROG" icon flashes.
Other Functions
3
Press PRESET+ or PRESET -/9 (or CH +/-
(¡ / ™) on the remote) to select the desired
preset number.
➜
If "PROG" icon goes off before you select the
desired preset number, press PROG on the
remote.
4
Press PROG on the remote again to store the
radio station.
●
Repeat steps 1-4 to store other radio stations.
Listening to preset radio stations
●
In tuner mode, press PRESET+ or PRESET -/9
(or CH +/- (¡ / ™) on the remote) to select
the desired preset number.
➜
The preset number, radio frequency, and
waveband are displayed.
Setting the clock
1
In Standby mode, press and hold CLOCK on
the remote until the time flashes on the display.
➜
"CLOCK SET" is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the hours.
3
Press CLOCK to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the minutes.
5
Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
69
Advertisement
Table of Contents
