Connect Power And Setup Dmx - Magicfx SWIRLFAN II User And Installation Manual

3.3

CONNECT POWER AND SETUP DMX

POWER
1. Connect a power cable with a Powercon TRUE1 Female connector to the
power input.
2. Connect the other end of the power cable to a 180 – 250 Vac (50 – 60 Hz)
power source.
3. Connect the female connector of a 5-pole DMX cable to the DMX input.
4. Connect the other end of the DMX cable to your DMX controller.
5. Power up the machine.
6. Use the display and buttons or a RDM controller to assign DMX addresses, see
Chapter 1.
7. Optionally see Section 3.7 for adding more machines to the same sequence.
CAUTION
16 MAGICFX® SWIRLFAN II — User and Installation Manual
5-pole female
DMX
PowerCon TRUE1 female
Always plug in a DMX Terminator into the DMX output. Using a
DMX Terminator improves signal reliability.
DMX IN DMX OUT
POWER IN POWER OUT