Get Started; Prepare The Remote Control; Plug & Play - Philips DCM109/93 User Manual

4 Get started

Caution
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
rear of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Caution
Risk of explosion! Keep batteries away from
3
1
2
1
Open the battery compartment.
2
Insert 2 AAA batteries (not supplied)
with correct polarity (+/-) as indicated.
3
Close the battery compartment.
12 EN
Note
If you are not going to use the remote control
for a long time, remove the batteries.
Do not use old and new or different types of
batteries in combination.
Batteries contain chemical substances, so they
should be disposed of properly.
Plug & Play
When you connect the unit to the power
is stored in this unit, Plug and Play mode is
activated to store all available radio stations
automatically.
1
Connect the unit to the power supply.
»
[AUTO INSTALL - PRESS PLAY,
STOP CANCEL] (auto install - press
the PLAY button; to cancel, press
) displays.
2
Press on the main unit to start
installation.
»
[AUTO] (auto) displays.
»
»
The unit automatically store radio
3
When all the available radio stations are
broadcast automatically.
Tip
If no key is pressed during Plug and Play
mode, the system goes to Standby mode
after timeout of 5 times. To go to installation
again, press and hold
Standby mode.
Toexit Plug and Play installation mode
1
press source keys or
control.
»
The system switches to the designated
source mode or standby mode.
for 3 seconds under
on the remote