Removing The Collected Water - G21 INTENSE Series Manual

Removing the collected water

There are two ways to remove collected water.
1. Use the bucket
• When the unit is off, if the bucket is full, the unit
will beep 8 times and the Full indicator light will
flash, the digital display shows P2.
• When the unit is on, if the bucket is full, the com-
pressor turns off and the fan turns off after 30 se-
conds for drying the water of the condenser, then
the unit will beep 8 times and the Full indicator light
will flash, the digital display shows P2.
• Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight so
water does not spill. Do not put the tank on the
floor because the bottom of the bucket is uneven.
Otherwise the bucket will fall and cause the water
to spill.
• Throw away the water and replace the bucket.
The bucket must be in place and securely seated
for the dehumidifier to operate.
• The machine will re-start when the bucket is res-
tored in its correct position.
Notes:
• When you remove the bucket, do not touch any
parts inside of the unit. Doing so may damage the
product.
• Be sure to push the bucket gently all the way
into the unit. Banging the bucket against anything
or failing to push it in securely may cause the unit
not to operate.
• When you remove the bucket, if there is some
water in the unit you must dry it.
2. Continuous draining
Water can be automatically emptied into a floor drain by attaching the unit with a water hose (not
included).
• Remove the rubber plug from the back drain hose outlet. Attach a drain hose (ID=13,5 mm) and
lead it to the floor drain or a suitable drainage facility.
• Make sure the hose is secure so there are n leaks.
• Direct the hose toward the drain, making sure that there are no kinks that will stop the water
flowing.
• Place the end of the hose into the drain and make sure the end of the hose is level or down to
let the water flow smoothly. Do never let it up.
• Select the desired humidity setting and fan speed on the unit for continuous draining to start.
Note: when the continuous drain feature is not being used, remove the drain hose from the outlet.
1. Pull out the bucket a little.
2. Hold both sides of the bucket with even
strength, and pull it out from the unit.
3. Pour the water out.
Attach the hose to the drain hose outlet.
Remove the
rubber plug.