Tape Operation / Recording; Tape Playback; Switching Tape Sides; Reverse Mode Options - Philips MC-222/22 User Manual

STANDBY-ON PROGRAM TIMER
ON
OFF
SOURCE
SELECT
RECORD PLAY•PAUSE STOP
PREV NEXT iR

Tape playback

1
Select TAPE source.
➜ The display shows TAPE briefly. The tape
counter TAPE 000 display with the
and reverse mode status are then shown
SIDE B
during tape mode.
2
Press OPEN to open the tape door.
3
Insert a recorded tape and close the tape door.
G Load the tape with the open side downward and
the full spool to the left.
Press PLAY•PAUSE 2; (on the remote
4
control 2;) to start playback.
By pressing ¡1 or 2™ on the system (on the
5
remote control à or á), fast winding of tape is
possible in both directions.
G During fast winding, you can monitor the tape
message with the tape counter.
To stop the tape, press STOP 9 .
6
G To reset the tape counter, press STOP 9 again.
Note:
– The sound source cannot be changed while
recording a tape.
RDS REPEAT SHUFFLE
REV
MODE
CLOCK SIDE A/B
BAND
or
SIDE A

Tape Operation / Recording

Switching tape sides

The tape side can be switched manually or
automatically before or during tape playback.
G Press SIDE A/B (during playback only 2; on
the remote control).
➜ The display shows
tape counter resets to 000.

Reverse mode options

G Press REV MODE repeatedly to select your
option;
å
: playback stops at the end of the tape.
: both sides are played once.
: both sides are played repeatedly, up
to 5 times each side.
General information on
recording
G Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
G For recording, use only NORMAL (IEC type I)
tapes on which the tabs have not yet been
broken. This deck is not suited for recording on
METAL (IEC IV) type tapes.
G The best recording level is set automatically.
Altering the VOLUME, INCREDIBLE
SURROUND, DBB or INTERACTIVE SOUND
controls will not affect the recording in progress.
G At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
G To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.
or and the
SIDE A SIDE B
17