Toro Reelmaster 5610 Owner's/Operator's Manual page 12

Note:
When installing or removing the
cutting units, make sure the hairpin cotter is
installed in the spring rod hole next to the
rod bracket. Otherwise, the hairpin cotter
must be installed in the hole in the end of
the rod.
6. Lower all lift arms completely.
7. Remove the lynch pin from the lift-arm pivot
yoke. Then, remove the cap
Figure 10
1. Lynch pin
8. For the front cutting units, slide a cutting unit
under the lift arm while inserting the carrier-frame
shaft up into the lift-arm-pivot yoke
Figure 11
1. Lift arm
2. Carrier-frame shaft
9. Use the following procedure on the rear cutting
units when the height of cut is above 19 mm
(3/4 inch).
A. Remove the lynch pin and washer securing
the lift-arm-pivot shaft to the lift arm and
(Figure 10).
g003975
2. Cap
(Figure 11).
g003977
3. Lift-arm-pivot yoke
slide the lift-arm-pivot shaft out of the lift
arm (Figure
1. Lynch pin and washer
B. Insert the lift-arm yoke onto the carrier-frame
shaft (Figure
C. Insert the lift-arm shaft into the lift arm and
secure it with the washer and lynch pin
(Figure 12).
10. Insert the cap over the carrier-frame shaft and
lift-arm yoke.
11. Secure the cap and the carrier-frame shaft to the
lift-arm yoke with the snapper pin
Note:
Use the slot if a steering cutting unit is
desired or use the hole if the cutting unit is to
be locked in position.
12. Secure the lift-arm chain to the chain bracket
with the snapper pin
Note:
Use the number of chain links described
in the cutting unit Operator's Manual.
1. Lift-arm chain
2. Chain bracket
13. On cutting unit 4 (left front) and cutting unit 5
(right front), insert the reel-motor hoses into the
respective hose guide.
14. Coat the spline shaft of the reel motor with clean
grease.
15. Oil the reel motor O-ring and install it onto the
motor flange.
12
12).
Figure 12
11).
(Figure
(Figure 13).
Figure 13
3. Snapper pin
g003979
10).
g003948