Summit 82069 Manual page 5

SEAT - 82075 PEAK
1. Position the stand so that you have access to the
seat support as shown in figure 11.
2. Lay the foam seat on the frame as shown in
figure 12.
3. Bring one of the straps up from the inside and
wrap it around the lower support bar. See figure
13.
4. Turn the three bar slide sideways and push it
through the D ring as shown in figure 14.
5. Your finished buckle should look like figure 15.
Repeat Steps 1 - 4 for the remaining buckles.
13
HANGING STRAP - ALL MODELS
The hanging strap will need to be assembled before
first use.
1. Using the diagram to the right, thread the free
end of the strap with the double J-Hook through
the buckle as shown.
2. A properly threaded strap should tighten when
the free end is pulled. It should loosen when the
buckle is rotated out away from the tree.
3. It is not necessary to un-thread the buckle after
this point.
WARNING
!
ALWAYS ensure the strap remains tight once pulled
tight. If the strap loosens DO NOT use the treestand.
Inspect the strap for proper buckle threading before
proceeding.
11
14
BUCKLE
FREE END
12
15
DOUBLE J-HOOK
HANGING TAB
TREE
Looking Down
HANGING TAB
DOUBLE J-HOOK
PG 5