Advertisement
1
Connect the AC power cord of the subwoofer to the AC outlet.
2
Connect the AC power adaptor of the system.
In case the wireless connection fails due to conflict or strong
interference etc., you may need the following procedures for
manual pairing:
1
In standby mode, press and hold 2; on the set for three seconds to
activate signal transmitting.
➜"PAIR" flashes on the display screen.
2
Press and hold the PAIR button on the rear of the subwoofer for
three seconds to activate signal receiving.
➜The LED indicator on the subwoofer flashes in blue and green
alternatively.
●
If the connection succeeds, the display shows "PASS".
●
If the connection fails or the connection cannot be set up successfully
within 60 seconds, the display shows "FAIL".
Setting the clock
1
In standby mode, press and hold
2
Press
VOLUME +/-
between 12 hour and 24 hour display.
3
Press
PROG/SET TIME
➜
The clock digits flash on the display panel.
4
Press
VOLUME +/-
5
Press
PROG/SET TIME
➜
The clock digits for the minutes flash.
6
Press
VOLUME +/-
set the minutes.
7
Press
PROG/SET TIME
PROG/SET TIME
(or
on the remote control) to switch
VOL +/-
on the remote control again to confirm.
(or
on the remote control) to set the hours.
VOL +/-
on the remote control again.
(or
on the remote control) to
VOL +/-
on the remote control to confirm the time.
on the remote control.
Tip
– See the User Manual for how to
connect other equipment to this
system.
– Use the supplied AC power
adaptor only! Using any other
power connection device may
damage your main set!
1
2
Advertisement
