Advertisement
5
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
Make sure this machine is used on a dry, flat, level, oil/grease free, concrete sur-
face capable of supporting the weight of the Wheel Balancer, the tire being bal-
anced, and any additional tools and equipment.
Before each use, always examine the wheel balancer for structural cracks and
bends, damage to the safety guard and electrical wiring, and any other condition
that may affect the safe operation of the machine. Do not use the Wheel Balancer
even if minor damage appears.
Maintain a safe working environment. Keep the work area well lit. Make sure there
is adequate surrounding workspace. Always keep the work area free of obstruc-
tions, grease, oil, trash, and other debris. Do not use the Wheel Balancer in a
damp or wet location. Do not use the Wheel Balancer in areas near flammable
chemicals, dusts, and vapors.
This wheel balancer is designed for use with most passenger car and light duty
truck wheels. Do not attempt to exceed this machine's maxi-mum wheel diameter
capacity of 31-1/2" or the maximum wheel width capacity of 20".
Prior to beginning a job, make sure the safety guard is in the proper lowered posi-
tion. do not raise the safety guard until the spinning wheel comes to a complete
stop.
Always keep hands, fingers, and feet away from the moving parts of the wheel bal-
ancer while the machine is in use. Remain clear of the spinning wheel while it is
being balanced.
Never leave the wheel balancer unattended when it is running. After completing a
wheel balancing job, always turn the Power Switch to its "OFF" position, and wait
until the machine comes to a complete stop before leaving.
Make sure to read and understand all instructions and safety precautions as out-
lined in the manufacturer's manual for the wheel you are balancing, and the vehicle
the wheel is to be used on.
Before turning the machine on, make sure tools, tool trays, wheel weights, and all
other parts and equipment are removed from the immediately vicinity of the
mounted wheel that is to be balanced.
Never stand or allow an observer to stand in line with the spinning wheel.
To comply with the National Electric Code, and to provide additional protection from
the risk of electrical shock, the Power Plug should only be connected to a 3-hole
electrical outlet that is protected by a Ground Fault Circuit Interrupter.
If an extension cord (not provided) is used, make sure to use only UL approved
cords having the correct gauge and length.
Always unplug the wheel balancer from its electrical supply source before perform-
ing any inspection, maintenance, or cleaning procedures
.
Hide quick links:
Advertisement
