Advertisement
weights, tools, etc, and remove the Tool Tray from the rest of the machine. Loosen the
four Nuts so that the Motor may be moved horizontally forward and backward. To tighten
the tension, move the Motor backward until the Pulley Belt is tight to the touch and re-
tighten the four Nuts. To replace the Pulley Belt, move the Motor forward to-ward the Pul-
ley. Remove the Pulley Belt from the Motor and Pulley, and replace it with a new Pulley
Belt. Then, move the Motor backward until the Pulley Belt is tight to the touch and re-
tighten the four Nuts. Attach the Tool Tray back onto the machine, and secure it in place
with the two Screws previously removed on the front and two Screws previously removed
on the back of the Tool Tray.
TO REPLACE THE FUSES: If it becomes necessary to replace the two electrical circuit Fuses,
remove the two Screws on the front and two Screws on the back of the Tool Tray. Empty the Tool
Tray of all weights, tools, etc., and remove the Tool Tray from the rest of the machine. Remove the
two Fuses from the Power Board and re-place them with two new Fuses. NOTE: Even if only one
Fuse is defective, it is recommended to always replace both Fuses at the same time.
With a soft brush, cloth, or vacuum, remove all debris from the Wheel Balancer.
When necessary, wipe with a damp cloth, using a mild detergent or mild solvent.
When storing, keep the Wheel Balancer covered with a clean cloth.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND AS-
SEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANU-
FACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY
KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY RE-PAIRS TO THE
PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PROD-
UCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EX-PRESSLY STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UN-DERTAKEN BY CERTIFIED
AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER RE-PAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARIS-ING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THER
19
Hide quick links:
Advertisement
