Integrated Panel Installation - U-Line 2200 Series Quick Start Manual

QUICK START GUIDE
QUICK START GUIDE

Integrated Panel Installation

1. Fully open door.
2. Starting at corner, pull
gasket away from door.
3. Continue to pull gasket
free from gasket channel.
4. Upon removal, lay gasket down on a flat surface.
5. The panel should be aligned with the outside edge
(opposite the hinge) and high enough to align with the
highest point in the door.
Align Top Of Panel With Highest Point Of Door
NOTICE
Due to differences in floor construction or
surrounding cabinetry, the panel may not sit
flush with the top of the door.
6. Secure integrated
7. Using a 7/64"
Align Panel
Against
Door Edge
First
NOTICE
It is important to ensure that all drilled holes are
drilled to the correct depth in order to avoid
splits in the wood when hardwood is installed.
8. Locate 6 of the #6x 1-1/2" (38 mm) screws provided
9. Using a Phillips screwdriver, place one screw into each
10.Ensure the screws sit flush against the bottom of the
6
6
panel to door using
clamps. A robust
tape may also be
used. U-Line
recommends the
use of bar clamps
Door/Drawer
to secure the panel
to the door. If using
tape, be certain the
tape will not
damage panel finish
upon removal.
(3 mm) drill bit, drill
6 pilot holes into
the wood panel 1/2"
(12 mm) deep using
the holes in the
door frame as a
guide.
with your unit.
of the 6 pilot holes and screw down. Do not overtighten
screws.
channel.
Integrated Panel
u-line.com
u-line.com
Bar
Clamp
Wood
Panel
Bar
Clamp
Integrated Panel