Voice Mode; Converting Act Voice Recordings To Wav Files - Apacer Technology Audio Steno AU822 User Manual

• A Directory Full message appears when the directory reached
its specified capacity (99 recording). Change the directory to
continue recording.
• Only the play button functions when in recording mode.
Selecting the voice recording format:
1. From the REC mode menu, press
menu.
2. Press or
3. Press to enter the Record Type sub-menu.
4. Press or
selection. Refer to the supported voice recording formats below.
Options
Fine sound recording
Long time recording
Fine sound control
Long time sound-control
15

Voice mode

You can use the Voice Mode menu to playback voice recordings. To do this:
1. Enter the main menu.
2. Press or
3. When in VOICE mode, press
4. Select the voice recording file, then press
5. Press or
6. Press , then press
again to confirm the volume after the adjustement.
16

Converting ACT voice recordings to WAV files

You may install and use the bundled Media Manager to ACT voice recordings
to WAV format. Make sure the audio recording files are saved to or sync with
your PC directory before converting the files to WAV.
To convert ACT files to WAV:
1. Install and run Media Manager to your PC.
2. Launch the tool, and then click Open.
then select Record Type.
to select the record type, then press
Fine sound quality in *.WAV format
General sound quality in *.ACT format
*.WAV format with sound-control recording and pause
recording when no sound is detected
*.ACT format with sound-control recording and pause
recording when no sound is detected
, then select VOICE mode.
.
to play the previous or the next voice recording.
or to increase/decrease the volume. Press
29
to enter the voice recording sub-
to confirm the
Format
to start playing.