Festool SYSLITE KAL II Original Operating Manual page 12

KAL II
The working light turns off and the
charging indicator switches to flashing
orange (charging) or continuous
orange (fully charged) depending on
the operating state.
In the event of an interruption to the
external voltage supply, the working
light automatically switches on.
Switching off the mode:
X Press the ON/OFF switch [1-2]
again. Charging indicator switches
to standard mode, see chapter 6.1.
6.6 Operating with external Festool
battery pack [2A] + [2B]
The working light can operate with
any Festool battery pack from the BPC
or BPS series. When connected to
the external Festool battery pack, the
working light only consumes power
from this battery pack.
Only compatible Festool chargers
can charge the Festool battery
pack.
6.7 Setup options
Attachment handle [1-3]
The folding attachment handle allows
you to hang the device from scaffolding
or similar structures.
If you decide to power the device
with an external Festool battery
pack, the attachment handle must
be detached beforehand [2A].
Setup angle
The working light can be set up in three
different angles [3].
Tripod
A standard photographic tripod with
UNC 1/4"-20 thread can be attached to
the threaded tripod socket [2-1].
12
Magnetic foot with spherical head (part
accessories) [4]
Strong magnetic fields
may damage or destroy
electronic or mechanical
elements and devices. The same also
applies to cardiac pacemakers. The
required safety distances can be found
in the manuals of these devices.
Risk of pinching fingers and
hands at the magnet!
Check the area at the magnetic foot
before use and clean if necessary.
Only use the magnetic foot for securing
the Festool working light using one of
the options described below:
Screw on magnetic foot at the tripod
socket [2-1]. This can be rotated in all
directions by loosening the clamping
screw [4-1].
Secure the magnetic foot using one of
three options:
[4A] Secure with a clamp
[4B] Magnetic mounting at the
screwed-on adapter plate
[4C] Magnetic mounting with the
adapter plate screwed to its
stand
7 Service and maintenance
Customer service and re-
pair. Only through manu-
facturer or service work-
shops: Please find the
nearest address at: www.
festool.com/Service
Always use original Festool
EKAT
4
spare parts! Order No. at:
5 www.festool.com/Service
3
2
1