Follow the instructions below to make sure that you install and use the product safely. • You may only connect this product using other products from Rusta’s lighting system (Belys). To connect the light, you must use a Belys transformer or another Belys product that is connected to the Belys system’s transformer.
ASSEMBLY 1. Screw the sections of the spotlight together. 2. Put the light into the ground. NOTE! Do not push the light into the ground. If the earth is hard, we recommend softening it up before putting the light in. Check that the light is firmly in place.
Läs bruksanvisningen noggrant och se till att produkten installeras, används och underhålls på rätt sätt enligt instruktionerna. Spara bruksanvisningen för senare bruk. FÖRPACKNINGENS INNEHÅLL • 1 gångbelysning Kensington 3W • 1 st markfäste VIKTIGT! För säker användning och installation följ nedanstående anvisningar.
MONTERING! 1. Sätt ihop belysningens rördelar. 2. Placera belysningen i marken. OBS! Tryck inte ned belysningen i marken. Är marken hård rekommenderas att den mjukas upp innan belysningen placeras. Kontrollera att belysningen sitter stadigt. 3. Anslut belysningen till Belys-transformator alternativt annan Belysprodukt vilken är ansluten till Belys-systemets transformator.
Page 6
Gangbelysning Kensington, 3W Les bruksanvisningen nøye og sørg for at produkten monteres, brukes og vedlikeholdes riktig i henhold til instruksjonene. Ta vare på bruksanvisningen for fremtidig bruk. INNHOLD • 1 stk gangbelysning Kensington 3W • 1 stk markfeste VIKTIG! For sikker bruk og installasjon følg instruksjonene nedenfor.
MONTERING! 1. Skru sammen belysningens rørdeler. 2. Plasser belysningen i marken. OBS! Ikke trykk ned belysningen i marken. Er marken hard, anbefales det å myke den opp før belysningen plasseres. Kontroller at belysningen sitter stødig. 3. Koble belysningen til Belys-transformator, alternativt et annet Belys-produkt som er koblet til Belys-systemets transformator.
Need help?
Do you have a question about the Kensington and is the answer not in the manual?
Questions and answers