Bluetooth Connection; Pairing; Multiple Bluetooth Connections; Disconnect From A Device - Bowers & Wilkins PX7 Manual

6. Bluetooth Connection

6.1 Pairing

PX7 is designed to stream media wirelessly from
Bluetooth audio devices, such as smartphones,
tablets or personal computers. To do so, the
headphone and device (source) must first be paired.
1. The first time you switch on your headphones,
Bluetooth pairing mode will be enabled,
the indicator will flash blue. If pairing mode
is not enabled, please slide and hold the
power switch to the upper (Bluetooth Icon)
position for 5 seconds, let go when the
indicator blinks blue and when an audible cue
is presented.
2. Ensure the Bluetooth feature is enabled on the
audio device, PX7 will appear in the discovery
list, select it to pair.
3. The indicator will flash blue while pairing is
in progress, this will change to solid blue
and an audible cue presented when pairing
is successful.
Your headphones will remember up to eight paired
Bluetooth devices. Repeat the above steps to pair
more devices.
Note: Your headphones will automatically exit
Bluetooth pairing mode if no device is paired
within 5 minutes. If pairing fails, the indicator will
rapid flash blue, please try pairing again.

6.2 Multiple Bluetooth Connections

PX7 can connect up to two devices at the same
time, but note that you can only play audio or take
calls from one device at a time.
To switch between two devices:
1. Pause audio on the first device, or use the
PX7 multi-function button.
2. Play audio from the second device and the
headphone will switch over.
When streaming audio, receiving a call on the
second device will automatically pause playback
and the call will be routed automatically to your
headphones. Ending the call will automatically
resume playback from the first device.

6.3 Disconnect from a Device

You can quickly disconnect PX7 from a device by
sliding the Power Switch to the upper (Bluetooth
Icon) position two times in quick succession, an
audible tone will be presented indicating successful
disconnection.
Alternatively, you can manage connection in further
detail using the Bowers & Wilkins Headphones app
under Connections.
6.4 Setting Up Headphones with the App
The Bowers & Wilkins Headphones app provides
extended setup and adjustments to features such as
Adaptive Noise Cancellation, Ambient Pass-Through,
and Wear Sensors. The app also provides further
customisations such as voice prompt, standby time,
connection management and headphone software
updates. The app is available as a free download on
iOS and Android devices.
To add your headphones:
1. From your mobile device, download and install
the Bowers & Wilkins Headphones app.
2. Launch the app, then read and follow
the instructions pertaining app notification
and permissions.
3. After reaching the main screen, simply tap +
and following the in-app instructions.
Diagram 7
Bluetooth pairing
6.5 Headphone Software Updates
Bowers & Wilkins will occasionally make available
software updates that refine and optimise the
performance of your headphones or add
new features.
The Bowers & Wilkins Headphones app will notify
you when a software update is available, tap on the
notification and the follow in-app instructions.
6