Cleaning And Storage - Omron Max Power Relief PM500 Instruction Manual

10. CLEANING AND STORAGE

The unit is designed for repeated use over time. The pads will last up to 150 uses, or
5 months (based on use one time per day). Here are important cleaning and storage
instructions:
Cleaning the pads
1. Turn the power off and remove the electrode cord from the pads.
2. Wash the pads when the adhesive surface becomes dirty and/or the pads are difficult to
adhere.
• Wash the pad softly with your fingertips under slow
running cold water for several seconds (do not use a
sponge/cloth/sharp object like a nail on adhesive side,
do not use detergents, chemicals or soap).
3. Pads can be washed after 15 uses, approximately ten times for up to 150 uses. Do not
wash the pads too long or too frequently.
4. Dry the non-sticky surface of the pads and let the adhesive surface air-dry completely.
Do not wipe with a tissue paper or cloth.
5. Pads are replaceable and can be purchased when needed by calling 1-800-634-4350
or going to OmronHealthcare.com
The life of the pads may vary by how often the pads are washed, the skin condition, and
how the pads are stored.
When should you replace your pads?
Replace the pads when they no longer stick to your skin or if more than 25 % of the pad's
surface is not in contact with your skin.
Cleaning the unit
1. Turn unit off and disconnect the electrode cords from the pads.
2. Clean with a lightly moistened cloth (or a cloth soaked in a neutral cleaning solution)
and wipe gently.
• Do not use chemicals (like thinner, benzene).
• Do not let water get into the internal area.
28