Adjustment; Tools, Gauges And Other Accessories; Abbreviations; Explanation Of Symbols - Pfaff 333-712/02 Adjustment Manual

13

Adjustment

Notes on adjustment
All adjustments in this manual are based on a fully assembled machine and may only be car-
ried out by technical staff trained for this purpose. Machine covers, which have to be re-
moved and replaced to carry out checks and adjustments, are not mentioned in the text.
The order of the following chapters corresponds to the most logical work sequence for ma-
chines that have to be completely adjusted. Both the preceding and following chapters must
be observed if only specific individual work steps are carried out. Screws and nuts indicated
in brackets () are fastenings for machine parts, which must be loosened before any adjust-
ment and tightened again afterwards.
13

Tools, gauges and other accessories

.01
O 1 set of screwdrivers with blade widths from 2 to 10 mm
O 1 set of wrenches with jaw widths from 7 to 14 mm
O 1 set of Allen keys from 2 to 6 mm
O 1 metal ruler (order no. 08-880 218-00)
O Needle rise gauge (order no. 61-111 600-01)
O Screw clamp (order no. 61-111 600-35)
13

Abbreviations

.02
t.d.c. = top dead centre
b.d.c. = bottom dead centre
13

Explanation of symbols

.03
Activities to be performed or important information in this adjustment manual are empha-
sised by symbols. The symbols used have the following meaning:
Observe and comply with all instructions in the operating manual's chapter
1 Safety! In particular make sure that all safety covers are installed again
correctly after making adjustments, see chapter 1.06 Operating manual
hazard information!
Unless otherwise stated, the machine must be disconnected from the electric
supplies before all adjustment work!
Risk of injury due to accidental machine start-up!
Note, information
Maintenance, repairs, adjustment, service work
(only to be carried out by technical staff)
Adjustment
5