Wahl Pet Starter How-To Manual page 28

OPERATING INSTRUCTIONS
Before the appliance is used for the first time it should be charged for 16 hours.
CHARGING THE RECHARGEABLE BATTERY
Connect the plug-in transformer to the power supply (fig1). Ensure the appliance is switched
off, otherwise it cannot be charged (fig2b).
Place the appliance on the charging stand. Whilst charging the charging indicator will
illuminate.
The charger indicator will go out when removed from the charging stand.
We recommend you only charge your appliance when its performance has deteriorated
noticeably.
Longer charging times do not damage the appliance.
It takes approximately 16 hours for the appliance to be fully charged.
Use only the charging transformer supplied with this kit, DO NOT attempt to charge with any
other transformer.
OPERATION OF RECHARGEABLE BATTERY
Using the ON/OFF switch, switch on the appliance (fig 2a) Switch off immediately after use.
ATTACHMENT COMB
Your appliance is supplied with a variable attachment comb. The attachment comb has five
settings. The further the attachment comb is pressed on to the appliance the shorter the
cutting length. In this way the cutting length can be varied between 3-6mm (fig 3).
To attach the comb, attach on to the appliance in the direction of the arrow until it locks into
position (fig 4a).
To remove push the comb in the direction of the arrow (fig 4b)
CHANGING THE BLADE SET
The blade set can be removed by pushing the blade set away from the housing in the
direction of the arrow see (fig 5a).
To replace blade set position it with the hook in the slot on the housing and press until it clicks
into place (fig 5b).
CLEANING AND MAINTENANCE
Never immerse the appliance in water.
Remove the attachment comb after each use and clean the blade set using the cleaning
brush.
Remove the blade set (fig 5) and clean the blade, press the cleaning lever (see fig 6). This
allows you to remove any hairs and dirt between top and bottom blade with the cleaning
brush (easy cleaning).
The charging contacts of the appliance must be kept clean. Use only a slightly damp cloth for
cleaning the housing and charging stand never use solvents or scouring agents.
Oil the blade set regularly using the oil supplied (fig 7) to maintain the cutting performance
and ensure a long service life. Replace the attachment comb to protect the blade when not in
use.
The blade set should be replaced if cutting performance is reduced after extended use.
WIRING
WARNING:
This product must only be used with the transformer supplied,
Should a replacement be required contact Wahl customer services.
28