Wahl Pet Starter How-To Manual page 26

WIRING
KMSS CLIPPER - WM6248
WARNING: If the supply cord is damaged it must be replaced by the manufacturers service agent or a
similarly qualified person in order to avoid a hazard.
The wires in the mains lead are coloured in accordance to the following code:
Blue Neutral (N)
This appliance is fitted with a 3 pin plug which has a 3 amp fuse fitted.
If the plug supplied is not suitable for your socket or becomes damaged, it should be cut off and disposed
of, and a suitable plug fitted as detailed below.
As the colours of the wires in the mains lead of this appliance may not correspond with the colour
markings identifying the terminals in your plug, proceed as follows.
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the
letter 'N' or coloured BLACK or BLUE.
The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with
the letter 'L' or coloured RED or BROWN.
DO NOT connect either wire to the terminal in the plug which is marked with the letter 'E' or has the Earth
symbol, or coloured GREEN or GREEN/YELLOW.
If a 13 amp (BS 1363) plug is used, a 3 amp fuse must be fitted. If any other type of plug is used a 5 amp
fuse must be fitted either in the plug or adaptor at the distribution board. Replacement fuses should be
approved to BS 1362
Fuse cover must be refitted when changing the fuse. If the fuse cover is lost the plug must not be used
until a replacement is obtained. Information for obtaining the correct fuse is marked on the carrier itself
and in the bottom of the fuse cavity in the plug. These may be obtained from Wahl (UK) Ltd.
WIRING
SS PRO CLIPPER - 9777
WARNING: If the supply cord / transformer is damaged it must be replaced by the manufacturers service
agent or a similarly qualified person in order to avoid a hazard.
26
Brown live (L)