Wahl Pet Starter How-To Manual page 21

BATTERY REPLACEMENT, REMOVAL AND DISPOSAL
Battery Replacement
For battery replacement the entire, intact trimmer should be sent to: Wahl (UK) Ltd Customer Services
(the address can be found on the reverse of this booklet) or taken to a suitably qualified professional. The
battery should only be replaced by the original manufacturers spare.
Battery Removal and Disposal
At the end of its life, when it will no longer take a full charge, the battery in your clipper must be removed
and recycled/disposed of correctly. Batteries should be disposed of at an official collection point. If you
are having trouble removing the battery you can also return the product to Wahl (UK) Ltd Customer
Services, who will dispose of it in an environmentally safe way.
To remove the battery, follow these steps:
1. Unplug the transformer from the outlet, disconnect from the clipper and allow the batteries to
completely run down before disassembly.
2. Remove the blade.
3. Using a Torx 7 screwdriver, remove the 2 screws found under the blade.
4. Prize the clipper housing apart along the join in the upper and lower casing.
5. Remove the motor and PCB assembly.
6. Remove the battery by prizing up from the PCB (take care not to puncture the battery).
7. Apply tape to both ends of the battery before recycling/disposing.
WIRING
WARNING:
This product must only be used with the transformer supplied,
Should a replacement be required contact Wahl customer services.
21