Rear Wheel - Yamaha TT-R125Y Owner's Manual

2. Insert the wheel axle, and then
install the washer and the axle nut.
3. Lower the front wheel so that it is
on the ground.
4. Tighten the axle nut to the
specified torque.
Tightening torque:
Axle nut:
45 Nm (4.5 m.kgf, 32 ft.lbf)
5. Push down hard on the handlebar
several times to check for proper
fork operation.
PERIODIC MAINTENANCE AND ADJUSTMENT

Rear wheel

To remove the rear wheel
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
1. Axle nut
2. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake
camshaft lever.
3. Turn the drive chain adjusting plate
on each side of the swingarm fully
in direction (a).
6 - 3 0
EAU25080
EAU25421
EWA10821
1. Adjusting nut
2. Brake rod
4. Lift the rear wheel off the ground
according to the procedure on page
6-28.
5. Remove the axle nut, and then pull
the wheel axle out.
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
1. Wheel
2. Drive chain
6