Temporarily Remove The Cable Separator - Permobil Halsa Owner's Manual

Permobil Hälsa Bed Owner's Manual

3.2 - Temporarily remove the cable separator

To make the electrical connections, you must temporarily remove the cable separator from the
bed's central motor. The cable separator is snapped in on each end of the underside of the motor.
Overview
WHERE CABLE SEPARATOR IS
SNAPPED IN UNDERNEATH
(LEFT SIDE IS UNDERNEATH)
Tool required: flat head screwdriver
STEPS
1 - Locate where the cable separator is connected on one side of the motor.
2 - While pushing in with a flat head screwdriver, push down until you can swing the cable
separator out.
PUSH IN WITH A
FLAT HEAD
SCREWDRIVER
3 - Repeat on the other side of the motor so you can remove the cable separator completely.
PUSH
DOWN
www.permobil.ca
3 – Connect the electrical systems
CABLE
SEPARATOR
SWING
OUT
15