Eaton CHMDENR100 Setup

Router Setup

Instruction Leaflet IL00412010E
System Requirements
Computer
Windows 98/2000 or Windows NT/XP.
200 MHz processor or greater.
64 MB of memory.
CD-ROM drive.
Ethernet adapter with TCP/IP protocol installed.
Internet Explorer 4.0 or greater/Netscape Navigator 4.0 or greater.
10/100 Ethernet card or adapter.
Modem
Cable or DSL modem with Ethernet port from the
service provider.
Step by Step Router Setup
1. The Broadband or DSL company will provide a modem for their
service. The modem should be placed near one of the comput-
ers in the home or in or near the Eaton structured wiring panel.
Do not plug in the power cords yet for each device.
2. Locate the Ethernet port on the modem. The Ethernet port will
be an RJ45 jack which is larger than your standard phone jack.
This port is usually located at the bottom of one side of the
modem.
FIGURE 1. MODEM
3. Locate the WAN port on your router. This port is located on the
right-hand side of the router on the same side as the computer
ports. The WAN port and computer ports will also be RJ45 jacks.
FIGURE 2. ROUTER
CHMDENR100
ESWN100
ESWN400
Incoming Signals
n o
WAN Port