Window Washer Fluid; Checking The 12-Volt Battery; Changing Wiper Blades - Acura MDX SPORT HYBRID 2018 Owner's Manual

MAINTENANCE

Window Washer Fluid

Add washer fluid as necessary (see page 136). Pour it carefully and do not
overflow the reservoir.
Washer Fluid Low
NOTICE
Do not use engine antifreeze or a vinegar/water solution in the windshield washer
reservoir. Antifreeze can damage your vehicle's paint. A vinegar/water solution can
damage the windshield washer pump.

Checking the 12-Volt Battery

The battery condition is monitored by the sensor on the negative terminal. If there
is a problem with the sensor, have your vehicle checked by a dealer. Check the
battery terminals monthly for corrosion.
Charging
System Problem
If your battery is labeled AGM, consult your dealer before you connect a battery
charger. AGM batteries require compatible chargers.
WARNING
The battery gives off explosive hydrogen gas during normal operation.
A spark or flame can cause the battery to explode with enough force to kill or
seriously hurt you.
When conducting any battery maintenance, wear protective clothing and a
face shield, or have a skilled technician do it.
WARNING: Battery posts, terminals, and related accessories contain lead and lead
compounds. Wash your hands after handling.
For Jump starting, see page 117.
140 |
If the washer fluid is low,
a message appears on the
multi-information display.
If there is a problem with
the battery sensor, a
message appears on the
multi-information display.

Changing Wiper Blades

If the wiper blades leave streaks across the windshield, try cleaning them first
with a paper towel or soft cloth and wiper fluid. If the wiper blade rubber has
deteriorated, you should change the wiper blades.
Front Wiper Blades
1. Lift the driver side wiper arm first, then the
passenger side.
2. Place a cloth on the edge of the lock tab. Push
the lock tab up with a flat-tip screwdriver.
3. Slide the blade holder from the wiper arm.
4. Slide the wiper blade out from its holder by
pulling the tabbed end out.
5. Remove the retainers from the rubber blade that
has been removed and mount to a new rubber
blade. Correctly align the rubber protrusion and
the retainer grooves.
6. Slide the new wiper blade onto the holder from
the bottom end. The tab on the holder should fit
in the indent of the wiper blade.
7. Slide the holder onto the wiper arm, then push
down the lock tab.
8. Lower the passenger side wiper arm first, then
the driver side.
NOTICE
Avoid dropping the wiper arm, as it may damage the windshield.
MAINTENANCE
Lock tab
Blade
Blade
Retainer
| 141