Sealing - Oasis FSC463R Installation & Operating Manual

CEILING ORIGINATED ELECTRICAL & REFRIGERATION LINES / KNOCKOUT REMOVAL / SEALING
1. Merchandiser Versatility
 Structural Concepts cases can accompany
either floor or ceiling-originated electrical and/or
refrigeration lines.
 This page shows how ceiling-originated lines
are routed into case.
2. Ceiling Routed Electrical/Refrigeration. Lines
 A center pass-through protective plate is mount-
ed at top of case over two (2) PVC
pass-throughs.
 If electrical/refrigeration lines are ceiling-
originated, remove plate knockouts.
 Electrical and/or refrigeration lines may then be
dropped through PVC center pass-throughs.
 Caution! If ceiling-originated lines are used,
you MUST seal both upper and lower PVC
Caution! If ceiling originated lines are
used, you MUST seal both upper and
lower PVC center pass-throughs (at
entrance points) with expandable
foam sealant to prevent
condensation in case.
center pass-throughs (at entrance points) with
expandable foam sealant to prevent
condensation in case.
3. Plate Removal
 Note: Though not required, protective plate can be
removed from merchandiser via four (4) screws.
4. Case Underside
 See REFRIGERATION FUNDAMENTALS:
center
UNDERSIDE LAYOUT (BOTH
SELF-CONTAINED & REMOTE) section in this
manual for location of center pass-throughs at
underside of case.
Center Pass-Through Protective
Plate Mounted on Merchandiser
8
Center Pass-Through
Protective Plate Shown After
Removal of Knock-Outs