Table of Contents
Advertisement
A wrench is supplied to loosen and tighten the screws.
4. (Optional) Install the water-proof jacket for network interface.
It is recommended to adopt the water-proof jacket (supplied) for
the network interface when the camera is installed outdoor.
1). If the network cable has been settled down, cut off the plug of
the network cable first.
2). Route the network cable through the following components in
sequence: fix nut, water-proof ring, and the main body of the
water-proof jacket, as shown in the figure.
3). Insert the water-proof ring into the main body of the
water-proof jacket, to increase the sealing ability of the
components.
4). Wire the plug and network cables up.
Network Camera·Quick Start Guide
Figure 2-18
Supplied Wrench
28
Advertisement
Table of Contents
