LUMENWERX RIM VERSO ACOUSTIX Installation Instructions

RIM VERSO ACOUSTIX
IMPORTANT: Installation instructions are shown with RIMR24 and applies to all RIM VERSO
This product must be installed in accordance
with the National Electrical Code and all
applicable local codes, by a person familiar with
the construction and operation of the product,
and the hazards involved. proper grounding is
required for safety.
Ce produit doit être installé suivant le code
national de l'électricité, ainsi que tous les codes
locaux applicables, par une personne familière
avec la construction et le fonctionnement
du produit, ainsi que tous les risques qui y
sont associés. la mise à terre électrique est
obligatoire pour la sécurité.
3
Use the canopy (B) as a model to mark 4 holes.
www.lumenwerx.com (T) 514-225-4304 (F) 514-931-4862 © All rights are reserved to LumenWerx ULC.
CANOPY DRIVER BOX - POC - INSTALLATION INST.
1
Slightly loosen the screws (A) on the side of the
canopy (B). Remove the canopy plate (C).
4
B
Remove the canopy. Drill holes (1/4" diameter)
following the red marks. Install #8 screw anchors(E).
LumenWerx ULC. reserves the right to change or modify product specifications without notification
NOTE: Wire dimming conductors as Class 1
2
A
B
C
Fix the canopy (B) on the junction box (D).
5
E
Tighten the two screws to secure the canopy (B)
to the Junction box (D).
RIM-VERSO-ACOUSTIX-CANOPY-DRIVER-BOX-POC-INST
W W W . L U M E N W E R X . C O M
D
D
B
February 13, 2020 Page: 1 / 3
B