Front Panel - Inter-m PAM-324 Operation Manual

PublIc Address AMPlIfIer

Front Panel

Front Panel
1
1. INPUT VOLUME CONTROL
※ set the controls of the unused input terminal to the minimum value.
The knobs are used to adjust the volumes of INPuT 1~6. Adjust the volume as you wish using the controls.
2. TONE CONTROL
※ carefully use the controls since the sound may get distorted and the amplifier may get damaged if the
The knobs are used to adjust the bAss (100 Hz) and Treble (10 kHz). You can adjust the tone as you wish.
controls are set too high.
3. MAIN VOLUME CONTROL
It is a control to adjust the volume of the entire signal set by each input volume control. Turn the knob
clockwise to increase the volume.
4. CHIME SWITCH
It is a switch to ring the chime of the 4-note scale. The chime indicator is turned on while the chime is
ringing.
5. SPEAKER SELECTION SWITCH
You can turn on/off the signal produced through each of the 5-speaker output terminals. Or you can turn
on/off the entire output signal by using the All switch. If a speaker output is turned on, the corresponding
※ Turn off the unused selection switch(es).
indicator on top of the switch will be turned on.
4 PAM-312/324/336/348
10
2
9 8
3 4 5
7
6