Valcom VIP-9895 Quick Start Manual

IP EMERGENCY WALL MOUNT CALL STATION
INTRODUCTION
The VIP-9895 IP Emergency Wall Mount Call
Station provides emergency communication to
any SIP telephone, SIP address, PC softphone,
Valcom intercom station or to a Valcom IP
Gateway. At the time of activation, the high
intensity blue LED changes from beacon mode
to flash mode. The LED will continue to flash
until the call is terminated. When the called
party answers, handsfree talkback
communication is enabled. When the called
party terminates the call, the connection is
terminated automatically.
SPECIFICATIONS
Features

Power over Ethernet (PoE) (802.3af)

Compatible with most modern IP telephone
systems

Call button calls a SIP address or any
Valcom Gateway

Automatic Talkback VOX operation (no push
to talk button needed)

SIP or Multicast addressable

All Call thousands of units with Valcom
Gateway

Red LED status indicator

Combination LED Beacon/Flasher

Compatible with secure networks

Supervision with alert functions

Network programmable for control and setup

High survivability – No server needed

Vandal and Tamper resistant

Stainless steel enclosure, brushed stainless
steel grille and hardware

Available in several standard color
combinations
Environment

Suitable for Indoor/Outdoor installations
VIP-9895
Mounting

Surface mount
Power

PoE: 802.3af, class 3
Speaker Output

100dB@4' on-axis

High efficiency design for voice
intelligibility
Networking

10/100 Mbps Ethernet port

Manual or Dynamic Host Configuration
Protocol (DHCP) IP address setup
Dimensions/Weights

32.15" H x 9.9" W x 8.0" D
(81.66 cm x 25.1 cm x 20.3 cm)

Shipping weight: 39.75 lbs. (18.1kg)
INSTALLATION
When removing or reinstalling security
screws, start screws by hand before
tightening with a hand or power driver tool.
If using a power driver, operate it at very low
speed to help prevent thread seizing.

Using security hex driver carefully remove
top and set aside with hardware.

Using the security hex driver, carefully
remove the front speaker panel. While
supporting the panel, unplug connector from
main circuit board at the top of the speaker
("A" in photo). Loosen screws from relay
connector on the small circuit board
attached to the speaker housing, and
disconnect the two white wires from the
relay ("B" in photo). Set speaker panel and
hardware aside.

Install base using appropriate hardware,
with supplied (4) 1.5" neoprene washers
between base and mounting surface.

Connect earth ground to base (ground may
be connected using one of the mounting
screws).
1
Issue 1
947534