Advertisement
Radio bus system
Radio wall transmitter, flat design
o
Press All Off button 1- for longer than 10 seconds.
Function has been deleted.
o
Exit programming mode of the receiver (see instructions for the receiver).
6 Appendix
Remove empty batteries immediately and dispose of in an environmentally friendly
manner. Do not throw batteries into household waste. Consult your local authorities
about environmentally friendly disposal. According to statutory provisions, the end
consumer is obligated to return used batteries.
6.1 Technical data
Rated voltage
Battery type
Ambient temperature
Relative humidity
Protection rating
Carrier frequency
Transmitting range in free field
Transmitting power
6.2 Troubleshooting
After a brief button-press the LEDs flash five times.
Cause: battery in the wall transmitter is almost empty.
Change battery (see section changing the battery).
Receiver does not respond, or only sometimes.
Cause 1: Radio range exceeded. Structural obstacles reduce the range.
Using a radio repeater.
Cause 2: function switches are in the wrong position.
Check positions of function switches.
6.3 Accessories
Base plate set for System 55 radio wall
transmitters, flat design
6.4 Warranty
The warranty is provided in accordance with statutory requirements via the specialist trade.
Please submit or send faulty devices postage paid together with an error description to your
responsible salesperson (specialist trade/installation company/electrical specialist trade). They
will forward the devices to the Gira Service Center.
32532712
10499114 I00
28.09.2011
max. 80 % (No moisture condensation)
433.42 MHz (ASK)
Order-No. 1110 00
DC 3 V
1×lithium CR 2032
0 ... +55 °C
IP 20
typical 30 m
< 10 mW
8/9
Advertisement
