Advertisement
Radio bus system
Radio wall transmitter, flat design
i If during saving of a light scene the blind is not in an end position, or is on the way there,
then that blind is not integrated into the light scene.
Call up All Off
In the teaching procedure for a channel button or a light scene button, the All Off button of the
receiver is automatically also taught, with the exception of radio blind actuators.
Function switch 1 is in the OFF position (see Commissioning).
o
Press button 1- longer than 1 second.
The loads at all taught receivers are switched off.
5 Information for electrically skilled persons
5.1 Fitting and electrical connection
Connecting and mounting the device
Maintain a distance of at least 1 m between transmitter and receiver.
Maintain distance from large-area metal objects, e.g. metallic door frames.
i Perform commissioning and teaching procedures before installation (see Commissioning
chapter).
o
Inset battery if necessary (see section Changing the battery).
Screw mounting
o
Using a screwdriver, carefully remove operating rockers (2).
o
Insert supplied threaded sleeves (4) through the screw holes from the rear.
o
Mount wall transmitter (1) directly to the wall using the screws (5) and anchors (3).
o
Attach operating rockers.
Glue mounting
In order to glue the wall transmitter directly to an even surface, e.g. glass, a base plate is
available (see chapter 6.3. Accessories).
32532712
10499114 I00
Figure 4: Screw mounting
28.09.2011
4/9
Advertisement
