Page 1
Radio bus system Radio wall transmitter, flat design Radio wall-transmitter flat design 1-g Order-No. : 1111 00 Radio wall-transmitter flat design 3-g Order-No. : 1113 00 Operating instructions 1 Safety instructions Electrical equipment may only be installed and fitted by electrically skilled persons.
Page 2
Radio bus system Radio wall transmitter, flat design The range of a radio system from the transmitter to the receiver depends on various circumstances. The range of the system can be optimised by selecting the optimal installation location, taking into account the structural circumstances. Figure 2: Reduced range due to structural obstacles Example of penetration of various materials: Material...
Radio bus system Radio wall transmitter, flat design 4 Operation Channel assignment of the wall transmitter Figure 3: Channel assignment Sending radio telegrams Press channel button, e.g. 1+, to transmit a radio telegram. The corresponding LED lights up as an acknowledgement. As long as no light scene functions were selected, the following responses occur, depending on the type of receiver: Button...
Page 4
Radio bus system Radio wall transmitter, flat design i If during saving of a light scene the blind is not in an end position, or is on the way there, then that blind is not integrated into the light scene. Call up All Off In the teaching procedure for a channel button or a light scene button, the All Off button of the receiver is automatically also taught, with the exception of radio blind actuators.
Page 5
Radio bus system Radio wall transmitter, flat design Figure 5: Glue mounting Glue base plate (6) directly to the surface. Using a screwdriver, carefully remove operating rockers (2). Fix wall transmitter (1) with the screws (7). Attach operating rockers. Figure 6: Glue mounting in a multiple combination i In order to use the wall transmitter in a multiple combination with glue mounting, the edge pieces (8) of neighbouring base plates have to be broken off at the predetermined breaking points.
Page 6
Radio bus system Radio wall transmitter, flat design Changing the battery WARNING! Risk of chemical burns. Batteries can burst and leak. Replace batteries only with an identical or equivalent type. Unscrew wall transmitter from the base plate or the wall and remove it (see section Connecting and mounting the device).
Page 7
Radio bus system Radio wall transmitter, flat design Press any button for approx. 1 second. 5.2 Commissioning Setting functions Wall transmitter is unscrewed from the base plate / the wall. Figure 9: Function switch i In the state as delivered all function switches are set to the ON position. Select functions of the buttons with the function switches according to the following table .
The warranty is provided in accordance with statutory requirements via the specialist trade. Please submit or send faulty devices postage paid together with an error description to your responsible salesperson (specialist trade/installation company/electrical specialist trade). They will forward the devices to the Gira Service Center. 32532712 10499114 I00...
Page 9
Radio bus system Radio wall transmitter, flat design Gira Giersiepen GmbH & Co. KG Elektro-Installations- Systeme Industriegebiet Mermbach Dahlienstraße 42477 Radevormwald Postfach 12 20 42461 Radevormwald Deutschland Tel +49(0)21 95 - 602-0 Fax +49(0)21 95 - 602-191 www.gira.de info@gira.de 32532712 10499114 I00 28.09.2011...