Sunrise Medical Zippie YOUNGSTER 3 Directions For Use Manual page 14

Lightweight footrest (Fig. 4.7)
The footboard angle can be adjusted by loosening the screws (2).
Side protection panels can be fitted to the footboard using the
mounting holes (3). These prevent the feet slipping off accidentally,
(Fig. 4.8). Make sure that after any adjustment work, all screws are
tightened correctly (see the page on torque).
Width adjustment
To adjust the width of the footboard open the screw (2). Then
you can slide in and out the tubes in the holder to adjust the
width of the footboard (Fig. 4.7).
Please make sure that the screws are tightened with the
correct torque .
Foot Plates
Angle-adjustable footplate (composite + aluminum) -
(Fig. 4.8 - 4.9)
The footplates can be flipped up to facilitate getting in
and out of your wheelchair.
The footplates can be adjusted within their angle of inclination,
relative to a level surface. Loosen screws (1 to 2). Then set the
footplates to the desired angle. Afterwards, tighten all screws.
After adjustment, always make sure that all screws are
tightened properly (see the page on Torque). In order to avoid
the wheelchair tipping over, make sure that the minimum
interval of 2.5 cm between the foot rest tubing and the ground is
maintained (with horizontal seat).
To adjust the width open the screws (1+2) then slide out
both brackets (3+4).
14
YOUNGSTER 3
Fig. 4.7
3
2
Fig. 4.8
1
2
Fig. 4.9
3 4
3
2