Displaying And Maintaining An Ethernet Interface - H3C S7500E-XS Series Interface Configuration Manual

Step
2. Enter Ethernet
interface view.
3. Set the MTU of the
Ethernet interface.

Displaying and maintaining an Ethernet interface

Execute display commands in any view and reset commands in user view.
Task
Display interface traffic statistics.
Display traffic rate statistics of interfaces
in up state over the last statistics polling
interval.
Display the operational and status
information of the specified interfaces.
Display information about dropped
packets on the specified interfaces.
Display information about storm control
on the specified interfaces.
Display the Ethernet statistics.
Clear interface statistics.
Clear the statistics of dropped packets
on the specified interfaces.
Clear the Ethernet statistics.
Command
interface interface-type interface-number
mtu size
Command
display counters { inbound | outbound } interface
[ interface-type [ interface-number ] ]
display counters rate { inbound | outbound } interface
[ interface-type [ interface-number ] ]
display interface [ interface-type ] [ brief [ down ] ]
display interface [ interface-type [ interface-number ] ] [ brief
[ description ] ]
display packet-drop { interface [ interface-type
[ interface-number ] ] | summary }
display storm-constrain [ broadcast | multicast | unicast ]
[ interface interface-type interface-number ]
display ethernet statistics slot slot-number
reset counters interface [ interface-type [ interface-number ] ]
reset packet-drop interface [ interface-type
[ interface-number ] ]
reset ethernet statistics slot slot-number
17
Remarks
N/A
The default setting is 1500
bytes.